Name: DS18 VOC8LD-PK
SKU: VOC8LD-PK
Availability: InStock

Description

DS18 VOC8LD-PK

The DS18 VOC8LD‑PK is a loaded Voceteo speaker enclosure package designed to deliver ready‑to‑play, high‑output midrange and high‑frequency sound for car audio and portable sound systems. This turnkey system includes dual 8″ PRO‑X8M mid‑range speakers and dual 3.78″ PRO‑TWX2 tweeters, all mounted in a ported (vented) enclosure built from ½″ MDF with a black carpet finish for durability and optimal acoustics. It also features a built‑in full‑range FRP‑1.2K4 Class‑D amplifier and a 12 ft OFC 4‑conductor Speakon cable with terminal for quick and clean connection — meaning you can install and play with minimal setup. With approximately 550 W RMS total power handling for the mid‑range section, 240 W for tweeters, 97 dB sensitivity, and 4 ohm impedance, this loaded box delivers clear, punchy vocals and detailed highs right out of the box.

Specifications

General Speaker Information

Item	Specification
Speaker Type / Size	Dual 8″ Mid-Range (PRO-X8M) + Dual 3.78″ Tweeter (PRO-TWX2)
Total Impedance	4 Ohms
Total RMS Power Handling	275 W
Total MAX Power Handling	550 W
Sensitivity (1W/1M)	97 dB
Frequency Response	80 Hz – 20 kHz
Recommended High-Pass Crossover	120 Hz

Enclosure Specifications

Item	Specification
Internal Volume	11.6 L / 0.41 ft³
Port Tune (Fb)	120 Hz
Load Configuration	Parallel
Enclosure Type	Side Ported
Enclosure Material	1/2” (15 mm) MDF
Finish Material	Black Carpet
-3 dB Dropping Point (F3)	80 Hz

Enclosure Measurements

Dimension	Inches	Millimeters
Height	22.25”	565 mm
Width	9.5”	241 mm
Depth	5.25”	133 mm

Amplifier (FRP-1.2K4) – Power Ratings

Configuration	RMS Power
4 Ω, per channel	120 W
2 Ω, per channel	200 W
1 Ω, per channel	300 W
4 Ω Bridge	350 W (2 channels)
2 Ω Bridge	500 W (2 channels)

Amplifier (FRP-1.2K4) – Audio Specifications

Item	Specification
Frequency Response	10 Hz – 20 kHz
Signal-to-Noise Ratio	90 dB
Efficiency @ 4 Ω	97%
Damping Factor	90
Input Impedance	10 kΩ
Total Harmonic Distortion (THD)	0.5%
Low-Level Input Range	400 mV – 6 V
Selectable X-Over	Yes (HPF / FULL / LPF)
X-Over Filter Range	10 Hz – 2 kHz
Bass Boost Frequency	50 Hz
Bass Boost Range	0 – 12 dB
Channel Separation	50 dB

Speaker Wire Specifications

Item	Specification
Connector Type	Speakon (Male)
Total Length	12 ft / 3.6 m
Conductor Material	Oxygen-Free Copper (OFC)
Number of Conductors	4
Wire Gauge	14 AWG
Nominal Outside Diameter	8 mm
Cable Construction Type	Stranded / Multi-Twist
Shield Material / Color	PVC / Black

Product Overview

8” Loaded Voceteo Enclosure with Tweeters, Full-Range Amp & Speakon Cable

DS18’s VOC8LD-PK brings the energy of the streets into a plug-and-play box that’s ready to get LOUD!

Loaded with dual 8″ PRO-X8M mid-range drivers, two ear-piercing PRO-TWX2 bullet tweeters, and powered by the mighty FRP-1.2K4 full-range amp—this system hits every note with serious punch.

Turnkey Voceteo Setup
This full-stack voceteo enclosure is built to skip the guesswork. We matched the enclosure, drivers, amp, and even tossed in a 12-foot 4-conductor Speakon cable for clean, fast setup. All you need is power.

Built Tough
Wrapped in sleek black carpet and made from ½” MDF, the VOC8LD-PK is road-tested and show-ready. With 550W RMS midrange power, 240W tweeter power, and a 4-ohm parallel load, it’ll keep your vocals cutting through no matter how wild the setup gets.

Amped to Perform
The included FRP-1.2K4 4-channel amplifier is compact, powerful, and fully loaded with HPF/LPF/FULL crossover settings, bass boost, and smart cooling tech. It delivers clean power at 1, 2, or 4 ohms, perfectly matched to your new loadout.

Get DS18’s VOC8LD-PK and bring the show to the streets!

Pro Tip: For max output and proper protection, pair this setup with DS18’s OFCKIT0 amp wiring kit. You’ll get the cleanest install and the strongest signal.